Position Overview

This position will utilize a saw machine to cut parts as directed. Make marks on material for cutting and guide material through saw cuts. The Sawing Machine Operator will clean, maintain lubricant levels, and service equipment to ensure continuous operation of machines.

Job Functions

• Cut material on table by placing on a table manually or using a hoist. Position and secure material on saw machine to guide material against saw. Turn controls to set cutting speed, feed rate, blade tension, and to adjust tilt of blade on table.


• Measure material to mark for cuts and to verify accuracy of cuts using rulers, squares, and other measuring devices. May be required to interpret a blueprint.


• Maintain equipment and coolant for proper machine operation. Install or adjust specified saw blade in machine using hand tools. Sharpen blades or replace defective or work blades.


• Check way-lube, hydraulic oil, grease, and oil levels on all machines in the machine shop.


• May operate Manual Lathes, Mills, and CNC Equipment.


• Locate material to correct bin location, record material on cut list. Re-color coats end of material.


• Move excess material to appropriate bin location.


• Spot check inventory counts.


• Empty machine shop chip hopper as needed.


• Ability to perform all essential job functions with or without reasonable accommodation.


• Perform all other duties as assigned.

Skills and Abilities

• Operate forklifts.


• General computer knowledge and proficiency.


• Ability to read a tape measure and use measuring devices and tools.

Demonstrated Competencies

• Attention to detail.


• Ability to concentrate on a task without being distracted.


• Ability to communicate information, in verbal and or written form.


• Must have regular and punctual attendance.

Physical Requirements

• Must be able to lift, push, and pull up to 60lbs.


• This position requires sitting, standing, walking, climbing, twisting, reaching, bending, and lifting.

Experience:Relevant work experience is preferred.

Education: High School diploma or equivalent is preferred. Verifiable ability to perform essential job functions may be substituted in lieu of formal education.

Department:Machining

Reports to (if applicable): Machine Shop Floor Supervisor